Kenner fences take a beating. Wind comes off Lake Pontchartrain, hurricane season runs June through November, and the soil stays wet for days after a storm. CMC's Services builds wood, vinyl, aluminum, composite and chain-link fences that are set to stay upright through all of it.
215+ 5-Star Google Reviews · Licensed & insuredA Kenner fence holds up to wind when the posts are set deep in concrete, spaced closer than usual, and paired with a panel style that lets some air through. A solid six-foot privacy fence acts like a sail in a strong gust off the lake, and on soft, wet ground the posts are the first thing to give. CMC's Services digs post holes deeper than a basic install, sets each post in concrete, and uses heavier posts at corners and gates where the load is highest. For homeowners near the lakefront or on open corner lots, we often suggest shadowbox wood, semi-private vinyl, or aluminum, since gaps between boards let wind pass instead of pushing the fence over. We install wood, vinyl, aluminum, composite and galvanized or coated chain link, and we repair and replace fences damaged by storms. Building for the wind costs a bit more up front and saves a full rebuild after the next big storm.
We serve homes and businesses across Kenner and Jefferson Parish, we are licensed and insured, and we have done this work for over a decade. The site visit and written quote are free, and we explain which styles stand up best on your part of town.
A fence built for local weather gives you privacy and security that last more than a few storm seasons.
Posts set in concrete with closer spacing are much less likely to lean or snap in a tropical storm. That means fewer calls for emergency repairs and fewer panels blown into the neighbor's yard. When a fence does take damage, a well-built one usually needs a section repaired, not the whole run.
Tall wood panels, composite boards and solid vinyl give Kenner backyards real seclusion. We build each run to consistent height and alignment so the top line stays level, even on lots that dip toward a drainage ditch or the back property line.
Chain link and aluminum fences keep people and equipment where they belong without blocking the view. For businesses near the airport and along Williams Blvd, we install perimeter fencing and lockable gates that secure the lot.
Vinyl, aluminum and composite resist rot, rust and warping in Kenner's humid climate. Pressure-treated wood is still a good value, and we use coated or stainless fasteners so hardware does not rust before the boards wear out.
We are a Jefferson Parish crew with local experience and straightforward pricing.
We work across Kenner, from Rivertown neighborhoods to subdivisions near the lake, and we understand how wind exposure, soil and drainage change from one part of the city to another.
For more than a decade we have built fences that combine strength and good looks, first as Premier Outdoor Living and now as CMC's Services.
We handle backyard privacy fences and commercial perimeter fencing, security enclosures and gates for businesses, using the same post-setting standards on both.
We focus on your goals, budget and property, explain material choices plainly, and give you a written quote. We have 215+ 5-star Google reviews.
Most fencing projects in Kenner take two to five days, depending on size, materials and weather.
We inspect your property, measure the fence line and look at wind exposure, soil and drainage. We talk about privacy, pets and how often you want to maintain the fence, then recommend materials that fit.
We lay out the fence line, gate locations and post spacing, choose materials and finalize the design. You get a written quote with materials, labor and any old-fence removal included.
The crew digs post holes, sets posts in concrete, hangs rails and panels, and installs gates and hardware. We check level and alignment as we go so the fence stands straight and sturdy.
We review the finished fence with you, test every gate and latch, and clean up the site. We do not call the job done until you are satisfied with the result.
We handle every part of fencing, from new installs to storm repairs.
Tall wood panels, composite boards and solid vinyl designs, built to a consistent height. Shadowbox and semi-private styles let wind through on exposed lots.
Low-maintenance vinyl in several colors and styles that resists moisture, pests and fading. A clean look that only needs an occasional wash.
Galvanized or vinyl-coated chain link in the height and wire gauge your property needs. Good for security, pets and commercial lots, with visibility through the fence.
Aluminum for an ornamental look that will not rust, and composite boards for privacy without rot or splinters. Both suit Kenner's humid air.
Replacing broken boards, resetting leaning posts and resealing worn wood. We match new boards to your existing fence so the repair blends in.
When a fence is past saving, we remove the old one, haul it away and install a new fence in the material you choose.
Kenner runs from the Mississippi River up to the lakefront, and homes on the north end feel the wind off Lake Pontchartrain more than most of Jefferson Parish. After a strong storm we see the same failures: posts set in plain dirt that rocked loose, gates that sagged because the hinge post was too light, and solid panels that pushed over as a single sheet. We design new fences to avoid those weak points.
Soggy soil is the other half of the problem. A post sitting in standing water rots or shifts faster, so we look at drainage along the fence line during the visit. If water pools along your property line, our Kenner drainage service can fix that before the new fence goes in. Pool owners can pair a fence with our pool construction in Kenner.
215+ 5-star Google reviews from homeowners across Metairie and New Orleans. Read them on Google.
“CMC Services just completed an amazing project covering our entire front of our house including new concrete driveways. The project involved demolition of all existing cement and grass with a new design for two separate driveways instead of the former circular driveway plus the addition of turf and decorative cement squares across the entire front and two new gardens with new pavers. From the moment we received their estimate last fall to the beginning of the project in February, our project manager, Matt was exceptional to work with and maintained communication with us throughout the entire project…”
“Had an issue with a city ordinance that should not exist and CMC made it right by fixing it free of charge! The rest of their work is very clean and exactly how they said it would be! Drainage work was much better and cleaner than expected. Their crew cleans up after themselves and leave no messes behind!”
“We worked with CMC services to install landscaping and lighting at our new Catholic Center. They did an excellent job and worked within our budget. Madeline came up with a beautiful design, and the work was done quickly and efficiently. They were a pleasure to work with. I would highly recommend them!”
“CMC'S has been our yard work for several years now and they do a excellent job. The pricing is very reasonable. The guys are professional and friendly. I would recommend CMC'S. They are the best!”
“My lawn looks great. I trust them to come into my backyard even when I am not home.”
“If you want your yard and garden to reflect the beauty of your home call CMC.”
“Been with Corey & CMC service people for a few years, all is good.”
“CMC's is extremely dependable and very reasonably priced!”
“Great service! Garden always looks great.”
Pressure-treated wood, vinyl and aluminum all work well here. Vinyl and aluminum need the least upkeep and resist rot and rust. Wood is a strong value for privacy and lasts longer when sealed. On windy, exposed lots, styles with small gaps between boards hold up better than solid panels. We help you weigh the tradeoffs at the visit.
Most projects take two to five days depending on the length of the fence, the material and weather. Larger or custom projects can take longer. Posts set in concrete need a short time to cure before panels go up. We give you a timeline with the estimate and update you if rain changes it.
Yes. We reset leaning posts, replace broken boards and panels, and rehang gates. If several posts have failed or the wood has rotted at the base, replacement may be the better choice. We look at the damage and tell you whether repair or a new fence makes more sense for your property.
Price depends on material, height, total length, gates and whether an old fence needs to be removed. Chain link is usually the most economical, while vinyl, aluminum and composite cost more up front but need less upkeep. We give you a free estimate with materials and labor laid out before work begins.
Yes. We build perimeter fences, security enclosures and gates for businesses in Kenner, including chain link and aluminum options. Commercial projects get the same post-setting standards as residential work so the fence stays secure through wind and storms.
Call, email or send the form. We will set up a time to walk your property and give you a written quote.
Open CMC's Services on Google Maps · 5245 York St, Metairie, LA 70001
Call (504) 608-4272 or fill out the form. We will walk your property line, check wind and drainage, and give you a written quote.
